Sanming one ton of plastic granules spot where dryer dryer instructions after selling 2.1 installed properly, the first line before you use the test machine, check the motor running direction, whether there will be abnormal sound operation of the machine, running smoothly. 2.2 Empty test run everything is normal, check to make sure the work can be carried out prior to feeding. 1) Clean the inner wall of the machine, make sure no debris contaminated material 2) when the machine has been shipped up and down the rolling bearing butter filling, but customers should be maintained since the extent of the use of plants, in principle, once per month Note butter. 3) Make sure the barrel on both sides of the discharge port is in the closed position the knife. 4) Make sure the knife clean the discharge port is plugged. 5) Make sure the entrance is on the barrel sealed, pressure deduction is no good after 2.3 above checks done, the work can be carried out feeding, the machine cast hopper built with shields, is mainly used to protect the operator's safety and isolation over 3X75px plastic block material set pieces. 2.4 feed, you can start the motor and by the proportion of different raw materials to set stirring time, a) particle material recommendations stirring time: After the increase of raw materials, recycling and stir for 30-60 minutes b) broken material recommendations stirring time: After the increase of raw materials, recycled materials do not stir for 60-90 minutes 2.5 full bucket, preferably full Jiucheng, stirring to avoid affecting the quality of the raw material is stirred 2.6 can be completed from the discharge spout, spout clean clear failure emptied 2.7 The raw material in the mouth clean clear material, use air guns to clean, non-state machine is in working with staff to clean up more than expected 2.8 proportion of different materials such as agitation, please be appropriate to increase the mixing time 2.9 To change the color you want to clean the mixing barrel, use air guns and clean mop to clean up, do not use direct water rinse to prevent rusting 2.10 chassis machine is not used for a long time, turn off the main power warning one, please pay attention to safety ladder climb aboard two machines work when prohibited by hand to get close to purge port 3, non-stirred 3X75px of material, so as not to screw stuck. 4, non-direct water to clean the machine inside wall 5, please butter filling every 10-15 days, filling parts: the center bearing chassis, the lid bearing belt positioning